motor operated valve

简明释义

电动阀

英英释义

例句

1.The control room operator adjusted the settings on the motor operated valve to regulate the flow of water in the pipeline.

控制室操作员调整了电动阀的设置，以调节管道中的水流。

2.During maintenance, the technician inspected the motor operated valve for any signs of wear and tear.

在维护期间，技术人员检查了电动阀是否有磨损的迹象。

3.An alarm sounded when the motor operated valve failed to close properly during the test.

在测试过程中，当电动阀未能正确关闭时，警报响起。

4.The motor operated valve is crucial for controlling the pressure in the gas distribution system.

在气体分配系统中，电动阀对于控制压力至关重要。

5.To enhance efficiency, the plant upgraded all manual valves to motor operated valves.

为了提高效率，该工厂将所有手动阀升级为电动阀。

作文

In modern industrial applications, the control of fluid flow is critical for ensuring efficiency and safety. One of the key components that facilitate this control is the motor operated valve. A motor operated valve (电动阀门) is an automated valve that utilizes an electric motor to open or close the valve, allowing or restricting the flow of liquids or gases in a pipeline. These valves are widely used in various industries, including water treatment, oil and gas, chemical processing, and HVAC systems.The primary advantage of using a motor operated valve is its ability to provide precise control over the flow rate and pressure of the fluids being transported. Unlike manual valves, which require human intervention to operate, motor operated valves can be controlled remotely and integrated into automated systems. This not only increases operational efficiency but also enhances safety by minimizing the need for personnel to be present in potentially hazardous environments.Another significant benefit of motor operated valves is their reliability and durability. These valves are designed to withstand high pressures and temperatures, making them suitable for a wide range of applications. The electric motors used in these valves are typically robust and can operate continuously without significant wear and tear. This longevity translates to lower maintenance costs and reduced downtime for industrial operations.Moreover, motor operated valves can be equipped with various sensors and control systems, allowing for real-time monitoring and adjustments. For example, in a water treatment plant, a motor operated valve can automatically adjust the flow of water based on the levels detected by sensors, ensuring optimal treatment processes. This level of automation not only improves efficiency but also helps in maintaining compliance with environmental regulations.However, it is essential to consider the potential challenges associated with motor operated valves. The initial installation cost can be higher compared to traditional manual valves due to the complexity of the electrical components and control systems. Additionally, if the power supply fails, the operation of these valves may be compromised unless backup systems are in place. Therefore, careful planning and consideration are necessary when integrating motor operated valves into existing systems.In conclusion, the motor operated valve (电动阀门) plays a crucial role in modern industrial processes by providing efficient, reliable, and precise control over fluid flow. Its advantages, such as remote operability, durability, and integration with automation systems, make it an invaluable asset in various sectors. As industries continue to advance towards greater automation and efficiency, the importance of motor operated valves will only increase. Understanding their functionality and applications is vital for anyone involved in engineering or industrial management, as these valves are integral to achieving operational excellence.